Use the copier precautions
First, put the copier environment to be appropriate, pay attention to anti-high temperature, dust, shock, but also pay attention to the place is not easy to touch the water. Do not place too much items on the copier to avoid stress and deformation of the upper panel. The most important thing is to put the copier in a well ventilated place, because the copier work will produce trace ozone, long-term exposure to the health of the operator harmful.
Second, we must pay attention to the copier's power supply problems, the general rated voltage of the copier 200V to 240V, the power outlet voltage is too high or too low will affect the normal work of the copier. Whether it is in the plug power supply, or troubleshooting cardboard, etc., should first turn off the copier power switch and then operate, otherwise it will shorten the service life of the copier, causing failure.
Third, a reasonable preheat to extend the copier is very helpful, every day should first preheat the copier for about half an hour, so that the copier to keep dry. And in the absence of a copy of the task for a long time, you should turn off the copier power to save energy, usually should let the copier work in the energy-saving state, to avoid frequent start-up on the copier's optical components damage. Copy the file when the file should also be accumulated, to a certain number of copies after a copy of the effective protection of optical components.
Fourth, at any time pay attention to the remaining amount of supplies, the amount of toner is not enough to issue a warning when the copier should be powder, or powder may not cause the copier failure. And when the powder is best not to choose low-quality toner, if the use of inferior toner will directly affect the copy effect, but also on the copier internal cartridges caused by wear and tear. More seriously, be sure to avoid the toner inside the copier, if the dust falls on the copier's working circuit board, it is easy to cause the circuit short circuit damage the copier.
5, when adding copy paper to properly place the copy paper, to use the high quality of the copy paper, paper tray can not exceed the thickness of the copier allowed to place. If the paper used is not standard or the thickness is too thick, it is prone to a multi-paper, no paper or paper jam phenomenon, serious damage to the internal paper feed device.
First, put the copier environment to be appropriate, pay attention to anti-high temperature, dust, shock, but also pay attention to the place is not easy to touch the water. Do not place too much items on the copier to avoid stress and deformation of the upper panel. The most important thing is to put the copier in a well ventilated place, because the copier work will produce trace ozone, long-term exposure to the health of the operator harmful.
Second, we must pay attention to the copier's power supply problems, the general rated voltage of the copier 200V to 240V, the power outlet voltage is too high or too low will affect the normal work of the copier. Whether it is in the plug power supply, or troubleshooting cardboard, etc., should first turn off the copier power switch and then operate, otherwise it will shorten the service life of the copier, causing failure.
Fourth, at any time pay attention to the remaining amount of supplies, the amount of toner is not enough to issue a warning when the copier should be powder, or powder may not cause the copier failure. And when the powder is best not to choose low-quality toner, if the use of inferior toner will directly affect the copy effect, but also on the copier internal cartridges caused by wear and tear. More seriously, be sure to avoid the toner inside the copier, if the dust falls on the copier's working circuit board, it is easy to cause the circuit short circuit damage the copier.
5, when adding copy paper to properly place the copy paper, to use the high quality of the copy paper, paper tray can not exceed the thickness of the copier allowed to place. If the paper used is not standard or the thickness is too thick, it is prone to a multi-paper, no paper or paper jam phenomenon, serious damage to the internal paper feed device.
Comments
Post a Comment